Interview Questions Answers.ORG

Interviewer And Interviewee Guide

Production Engineer Interview Question:

Download Interview PDF

Next ❯❮ Previous

The tool made of cemented carbide wear out faster at:

A. slow speeds
B. medium speeds
C. fast speeds
D. very fast speeds

Submitted by: Administrator

A. slow speeds
Submitted by:

Next ❯❮ Previous

Read Online Production Engineer Job Interview Questions And Answers

Top Production Engineer Questions

☺	A single point thread cutting tool should ideally have: A. zero rake angle B. positive rake angle C. negative rake angle D. point angle

☺	The different spindle speeds on a lathe form: A. arithmetical progression B. geometrical progression C. harmonical progression D. any one of these

☺	Drilling is an example of: A. orthogonal cutting B. oblique cutting C. simple cutting D. uniform cutting

☺	In hot machining, tool is made of: A. tungsten carbide B. brass or copper C. diamond D. stainless steel

☺	A drill considered as a cutting tool having zero rake, is known as a: A. flat drill B. straight fluted drill C. parallel shank twist drill D. tapered shank twist drill

Top Best Engineering Categories

☺	Mechanical Engineering Interview Questions.

☺	Civil Engineering Interview Questions.

☺	Chemical Engineering Interview Questions.

☺	Electrical Engineering Interview Questions.

☺	Automobile Engineering Interview Questions.

SHARE

Disclaimer

Interview Questions Answers .ORG is responsive and optimized web portal for individuals to get preparation for their job interviews, learning and training. Content at Interview Questions Answers .ORG might be simplified to improve our users experience. We constantly review our content to avoid errors and copyright violations, but we cannot warrant full correctness of all the content. While using this site, you agree to have read and accepted our terms of use, cookie and privacy policy. Copyright 2007-2024 by Interview Questions Answers .ORG All Rights Reserved.