Fork Operator Interview Question:

Explain FORKLIFT SAFETY CHECKLIST?

Submitted by: Muhammad

☛ Qualified Operators– Drivers must have proper training and licensing to operate material handling transportation equipment. According to OSHA, only trained and authorized personnel may operate forklift equipment.
☛ Daily Inspections– Forklift trucks require daily safety checks as well as inspection prior to use. Trucks that aren't functioning properly should be removed from service.
☛ Consider the Operating Environment– Forklift routes should always be inspected for hazards such as loose materials, low overhead clearance and unstable loading ramps and bridge plates. Avoid bumps, holes and wet areas. Train tracks, elevators and ramps should be navigated carefully.
☛ Don't Overload the Forklift– Operators should understand the load capacity for the forklift and be sure not to overload it.
☛ Maintain Load Stability– Operators should inspect all loads for balance and stability. Loads need to be symmetrical with a low center of gravity. When driving on ramps, loads should be higher than the body of the forklift. Forklifts should be driven up ramps but driven down in reverse.
☛ Maintain Visibility– Loads should be short and carried low to the ground to avoid restricting driver visibility. The forklift can be driven in reverse to improve visibility. A lookout may be needed to navigate around corners or when high stacks are necessary.
☛ Follow Company Safety Rules– Forklift operators should obey all company regulations concerning material handling. They should also use Personal Protective Equipment (PPE), follow the speed limit and fasten their seatbelt.
☛ Caution in Pedestrian Areas– Forklift drivers should exercise extreme caution when navigating pedestrian areas, intersections, corners, stairways, exitsand entrances.
☛ Refuel Safely– Forklifts should be refueled at designated locations with the engine turned off and while avoiding open flames and sparks.
☛ Shutting Down– If left unattended, forklifts should be parked in designated areas with the parking brake applied and keys removed from the ignition.
Submitted by: Muhammad