Instrumentation Specialist Interview Question:

General Instrumentation Specialist Job Interview Questions:

Submitted by: Muhammad

☛ How can I make calculation to Install level transmitter (DP) for open tank and close tank?
☛ What is difference between DO and DI?
☛ What is loop1 and loop2 in MTS LT?
☛ How to calibration a control valve?
☛ What is dry leg calibration and where is it used?
☛ How flow can be measured with dp?
☛ Why MMWC unit is used?
☛ How HART protocol can be connected with control valves?
☛ What is the meaning of slope in PH transmeter?
☛ What is Difference between PLC and CNC?
☛ If we have 450 mm height boiler drum level, so what is span & zero value for a dpt transmitter?
☛ How can level transmitter in closed tank application be used?
☛ Why ac supply load cell is used? Can we use the dc supply load cell?
☛ What are advantages and disadvantage of the ac supply load cell?
☛ What is coriolis principle for mass flow meter?
☛ What are the automatic controller MODES?
☛ What is Cryogenic?
☛ What happen if we install my pressure transmitter below the elevation of pipe in natural gas service?
☛ What are the reliability data, like failure rate etc, for bently Nevada systems & vibration probes?
☛ What is the meaning of wet leg & where is it used?
Submitted by: Muhammad