Interview Questions Answers.ORG
Interviewer And Interviewee Guide
Interviews
Quizzes
Home
Quizzes
Interviews Basic Professional Interviews:AerospaceAgricultureAnatomyArchitectureArchitecture DesignAuto MechanicBabysittersBeautyBookkeeperCabin CrewCall CenterCapacitor PlanningCarpenterChefCIVIL ServicesClericalClerkDesigningDiplomacyDriverDrivingElectricianFashion & ModelingFashion ModelFire OfficerFirefighterFitnessFlight AttendantForklift OperatorGardeningHead of DisasterImaginationInterior DesignerInterpersonal SkillsInventivenessKids NannyLAWLaw EnforcementLawyerLeadershipLegal AssistantLegal Firms Law ResearcherLibrarianLibrary AssistantModelMotivationalNews ReporterPainterPeople SkillsPlumbingPolice OfficerProjectReceptionistResourcefulnessRisk TakingSafety SkillsSecretarialSnow BlowerSocial WorkerSQA EngineerTop Paying ProfessionsTrainingWelding
Copyright © 2018. All Rights Reserved
Welding Interview Question:
What is the required maintenance for welding robots?
Submitted by: AdministratorWelding robots have their own set of maintenance needs. Robotic welding systems have to keep everything regulated correctly - torch angle, wire feed, gas flow. As with most equipment, when it comes to welding robots, a little maintenance goes a long way. RobotWorx recommends paying attention to these items for the best results:
* Proper connection of welding leads: Positive from power source to wire feeder and negative from power source to work piece, table, and fixture.
* Wire feeder: The wire drive roll needs to have the proper tension and the rollers must be the proper size.
* Welding Gun: Check the condition of torch contact tips, nozzles, and make sure there is the right amount of gas flowing through the gun.
* Robot Tool Center Point (TCP): Make sure you've programmed this point correctly. It controls the torch's position and makes it possible for the robot to perform the proper movements.
Submitted by: Administrator
* Proper connection of welding leads: Positive from power source to wire feeder and negative from power source to work piece, table, and fixture.
* Wire feeder: The wire drive roll needs to have the proper tension and the rollers must be the proper size.
* Welding Gun: Check the condition of torch contact tips, nozzles, and make sure there is the right amount of gas flowing through the gun.
* Robot Tool Center Point (TCP): Make sure you've programmed this point correctly. It controls the torch's position and makes it possible for the robot to perform the proper movements.
Submitted by: Administrator
Copyright 2007-2024 by Interview Questions Answers .ORG All Rights Reserved.
https://InterviewQuestionsAnswers.ORG.
https://InterviewQuestionsAnswers.ORG.