Data Communications Interview Question:

What is the effect of noise?

Submitted by: Administrator

Noise may be defined as the combination of unwanted interfering signal sources whether it comes from crosstalk, radio frequency interference, distortion, or random signals created by thermal energy. Noise impairs the detection of the smallest analog levels which may be resolved within the demodulator. The noise level along with the maximum clip level of an analog signal path set the available amplitude dynamic range.

The maximum data rate of a modem is limited by the available frequency range (bandwidth) and signal-to-noise ratio (SNR) which is amplitude dynamic range. If more of either is available, more bits may be transferred per second. The information carrying limit was discussed theoretically by Claude Shannon and is known as Shannon's limit, or information theory.

Because modems run close to Shannon's limit today, no further advances will be made to traditional telephone line modems other than incremental improvement of V.90. The frequency range of the audio channel is very limited at about 4 kHz. V.34+ modems are limited to a maximum data rate of 33.6Kb/s by an SNR of about 36 dB caused mostly by network PCM quantization noise. While V.90 improves the SNR by utilizing the network PCM levels directly, it is still subject to Shannon's limit.

xDSL modems take advantage of the spectrum above the telephone audio channel. While operating with somewhat less amplitude dynamic range they increase data rates by greatly increasing the frequency range of the communication signal (from about 10 kHz to over 1.0mHz). To do this they require the installation of special equipment at the central office and customer premise.
Submitted by: Administrator