Interview Questions And Answers Forum

Ibraheem

Webmaster

From: Capital

Registered: 2012-03-16

Posts: 23,140

Website

Automobile Engineering Interview Questions And Answers

Engineering :: Automobile Engineering Job Interview Questions and Answers

Automobile Engineering job interview questions and answers guideline. Lean Automobile Engineering and get preparation for the job of Automobile Engineering

1 ► WHY BIG TYRE USED IN REAR OF VEH?
2 ► WHAT IS KING PIN OFFSET?
3 ► What is the formula for calculating BHP IN SI UNITS?
4 ► Explain different between two stroke engine four stroke engine?
5 ► For the purpose of inflating car tyres, spray painting, etc. i.e. say a small workshop, what size of a compressor (CFM) is recommended? It will be generally for a hobby use and not commercial use?
6 ► does the design & fittings vary on the type of the vehicle engine.. why they use petrol for engines only & vice versa?
7 ► By mixing oil in fule of four stroke bike will it damage engine, performance? if not than what happen?
8 ► What is BHP & How it is measured?
9 ► WHAT IS THE DIFFRENCE BITWEEN BS2 & BS3 ENGINE?
10 ► WHAT IS THE MEANING OF CC OF ENGINE?
11 ► What is a injecter pressure in heavy viehle?
12 ► What is the range of the engine efficiency for two stroke engine? Why you don’t see two stroke engine in car? What are problem with two stroke engine?
13 ► Why tractor rear wheel is big then front wheel?
14 ► WHAT IS TRANSVERSE WEIGHT SHIFT DUE TO DRIVE TORQUE?
15 ► What is staring  oil grade SAE nos of gear box,in passenger car?
16 ► WHY THE COLOR OF VEHICLE TYRES ARE ALWAYS BLACK IN COLOUR.IS THERE ANY THING RELATED WITH HEAT CONDUCTION?
17 ► What is the working principle of hydrostatic propeltion system in a tractor?