Interview Questions Answers.ORG

Interviewer And Interviewee Guide

Design Engineer Interview Question:

Download Interview PDF

Next ❯❮ Previous

The resistance to fatigue of a material is measured by

A. elastic limit
B. Young's modulus
C. ultimate tensile strength
D. endurance limit

Submitted by: Muhammad

Option D
Submitted by: Muhammad

Next ❯❮ Previous

Read Online Design Engineer Job Interview Questions And Answers

Top Design Engineer Questions

☺	The size of a gear is usually specified by A. pressure angle B. pitch circle diameter C. circular pitch D. diametral pitch

☺	The number of slots in a 25 mm castle nut is A. 2 B. 4 C. 6 D. 8

☺	When a nut is tightened by placing a washer below it, the bolt will be subjected to A. tensile stress B. compressive stress C. shear stress D. none of these

☺	According to Indian standard specifications, 100 H6/g5 means that the A. actual size is 100 mm B. basic size is 100 mm C. difference between the actual size and basic size is 100 mm D. none of the above

☺	When a bolt is subjected to shock loading, the resilience of the bolt should be considered in order to prevent breakage at the A. head B. shank C. thread D. middle

Top Best Multimedia Categories

☺	Coreldraw Interview Questions.

☺	Graphics Designer Interview Questions.

☺	Design Engineer Interview Questions.

☺	3D Animation Interview Questions.

☺	Interior Design Interview Questions.

SHARE

Disclaimer

Interview Questions Answers .ORG is responsive and optimized web portal for individuals to get preparation for their job interviews, learning and training. Content at Interview Questions Answers .ORG might be simplified to improve our users experience. We constantly review our content to avoid errors and copyright violations, but we cannot warrant full correctness of all the content. While using this site, you agree to have read and accepted our terms of use, cookie and privacy policy. Copyright 2007-2024 by Interview Questions Answers .ORG All Rights Reserved.