Hardware Design interview questions part 2:
Submitted by: Murtaza11. What is the dissipation factor? How is it calculated?
12. Explain tolerance?
13. What is a potentiometer used for?
14. What are the various hardware design tools available?
15. What is a HDL?
16. How can a two input NAND gate be converted into an inverter?
17. Define set up time & hold time constraints?
18. Draw a circuit to divide the clock frequency by half.
19. Design a divide-by-3 sequential circuit with 50% duty circle.
20. What are adder circuits explain?
Submitted by: Murtaza
12. Explain tolerance?
13. What is a potentiometer used for?
14. What are the various hardware design tools available?
15. What is a HDL?
16. How can a two input NAND gate be converted into an inverter?
17. Define set up time & hold time constraints?
18. Draw a circuit to divide the clock frequency by half.
19. Design a divide-by-3 sequential circuit with 50% duty circle.
20. What are adder circuits explain?
Submitted by: Murtaza
Read Online Hardware Design Job Interview Questions And Answers
Top Hardware Design Questions
☺ | Draw a Transmission Gate-based D-Latch? |
☺ | Design a divide-by-3 sequential circuit with 50% duty circle. |
☺ | Suppose you have a combinational circuit between two registers driven by a clock. What will you do if the delay of the combinational circuit is greater than your clock signal? |
☺ | How do you detect a sequence of "1101" arriving serially from a signal line? |
☺ | Give the truth table for a Half Adder. Give a gate level implementation of the same. |
Top PC Hardware Categories
☺ | Motherboard Interview Questions. |
☺ | Basic Computer Interview Questions. |
☺ | Embedded Systems Interview Questions. |
☺ | A + (Plus) Hardware Interview Questions. |
☺ | Computer Architecture Interview Questions. |