Hardware Design interview questions part 3:
Submitted by: Murtaza21. Give the truth table of a half-adder?
22. What are transmission gates?
23. What do you understand by DFT?
24. What are fault models?
25. Explain scan technologies
26. Explain BST?
27. What are the differences between BST and BIST?
28. State the differences between LFSR and MISR?
29. What is IDDQ?
30. What do you understand by the term recovery design?
Submitted by: Murtaza
22. What are transmission gates?
23. What do you understand by DFT?
24. What are fault models?
25. Explain scan technologies
26. Explain BST?
27. What are the differences between BST and BIST?
28. State the differences between LFSR and MISR?
29. What is IDDQ?
30. What do you understand by the term recovery design?
Submitted by: Murtaza
Read Online Hardware Design Job Interview Questions And Answers
Top Hardware Design Questions
☺ | Draw a Transmission Gate-based D-Latch? |
☺ | Design a divide-by-3 sequential circuit with 50% duty circle. |
☺ | Suppose you have a combinational circuit between two registers driven by a clock. What will you do if the delay of the combinational circuit is greater than your clock signal? |
☺ | How do you detect a sequence of "1101" arriving serially from a signal line? |
☺ | Give the truth table for a Half Adder. Give a gate level implementation of the same. |
Top PC Hardware Categories
☺ | Motherboard Interview Questions. |
☺ | Basic Computer Interview Questions. |
☺ | Embedded Systems Interview Questions. |
☺ | A + (Plus) Hardware Interview Questions. |
☺ | Computer Architecture Interview Questions. |