Tell me why is stress considered important in a shaft?
Submitted by: MuhammadThe following types of stresses are prevalent in shafts:
☛ > At the outermost surface of the shaft the max shear stress occurs on the cross-section of the shaft.
☛ > At the surface of the shaft on the longitudinal planes through the axis of the shaft the maximum longitudinal shear stress occurs.
☛ > At 45 degrees to the maximum shearing stress planes at the surface of the shafts the major principal stress occurs. It equals the max shear stress on the cross section of the shaft.
☛ > For certain materials where the tensile and compressive strengths are lower in measure as compared to the shear strength, then the shaft designing should be carried out for the lowest strengths.
☛ > All these stresses are of significance as they play a role in governing the failure of the shaft. All theses stresses get generated simultaneously and hence should be considered for designing purposes
Submitted by: Muhammad
☛ > At the outermost surface of the shaft the max shear stress occurs on the cross-section of the shaft.
☛ > At the surface of the shaft on the longitudinal planes through the axis of the shaft the maximum longitudinal shear stress occurs.
☛ > At 45 degrees to the maximum shearing stress planes at the surface of the shafts the major principal stress occurs. It equals the max shear stress on the cross section of the shaft.
☛ > For certain materials where the tensile and compressive strengths are lower in measure as compared to the shear strength, then the shaft designing should be carried out for the lowest strengths.
☛ > All these stresses are of significance as they play a role in governing the failure of the shaft. All theses stresses get generated simultaneously and hence should be considered for designing purposes
Submitted by: Muhammad
Read Online Design Engineer Job Interview Questions And Answers
Top Design Engineer Questions
☺ | Tell me what is mechanism? |
☺ | Tell me what is Hess law? |
☺ | Tell me what does a pump develop? |
☺ | Tell me the difference between projectile motion and rocket motion? |
☺ | Tell me why re-heater is used in gas turbine? |
Top Designing Categories
☺ | Web Designing Interview Questions. |
☺ | 3D Maya Interview Questions. |
☺ | Textile Dyeing Specialist Interview Questions. |
☺ | Fashion Designer Interview Questions. |
☺ | Physical Product Designer Interview Questions. |