Write a code to connect Hardware interrupt to ISR?
Submitted by: AdministratorIn Keil
void serial_ISR() interrupt 4 using 0
{
}
& in AVR studio
SIGNAL(Inteerupt_no)
{
}
hardware intterupt normally redirects the uC to predefined
addresses. In case of high end processors the interrupt
table will decide the interrupt vector address and whenever
intterrupt pin goes low, the table is searched for type and
source of interrupt.
Submitted by: Administrator
void serial_ISR() interrupt 4 using 0
{
}
& in AVR studio
SIGNAL(Inteerupt_no)
{
}
hardware intterupt normally redirects the uC to predefined
addresses. In case of high end processors the interrupt
table will decide the interrupt vector address and whenever
intterrupt pin goes low, the table is searched for type and
source of interrupt.
Submitted by: Administrator
Read Online RTOS Job Interview Questions And Answers
Top RTOS Questions
| ☺ | What is difference between IRQ and FRQ? |
| ☺ | Write a code to connect Hardware interrupt to ISR? |
| ☺ | What is task spawn in vxworks? |
| ☺ | What is major concerns about any RTOS selection? |
| ☺ | What is priority inversion? And What is the solution? |
Top Operating System (OS) Categories
| ☺ | RTOS Interview Questions. |
| ☺ | Windows 7 Interview Questions. |
| ☺ | MAC Operating System Interview Questions. |
| ☺ | Disk Operating System (DOS) Interview Questions. |
| ☺ | Shell Scripting Interview Questions. |
