Write a code to connect Hardware interrupt to ISR and explain?
Submitted by: AdministratorIn Keil
void serial_ISR() interrupt 4 using 0
{
}
& in AVR studio
SIGNAL(Inteerupt_no)
{
}
hardware intterupt normally redirects the uC to predefined
addresses. In case of high end processors the interrupt
table will decide the interrupt vector address and whenever
intterrupt pin goes low, the table is searched for type and
source of interrupt.
Submitted by: Administrator
void serial_ISR() interrupt 4 using 0
{
}
& in AVR studio
SIGNAL(Inteerupt_no)
{
}
hardware intterupt normally redirects the uC to predefined
addresses. In case of high end processors the interrupt
table will decide the interrupt vector address and whenever
intterrupt pin goes low, the table is searched for type and
source of interrupt.
Submitted by: Administrator
Read Online VxWorks Job Interview Questions And Answers
Top VxWorks Questions
| ☺ | What is priority inversion? |
| ☺ | Explain task spawn in vxworks? |
| ☺ | Write a code to connect Hardware interrupt to ISR and explain? |
| ☺ | What is another for creating a task without using taskspawn? |
| ☺ | Which RTOS supports Non-Preemptive scheduling? Why other scheduling methods are supported by such Oses? |
Top Operating System (OS) Categories
| ☺ | RTOS Interview Questions. |
| ☺ | Windows 7 Interview Questions. |
| ☺ | MAC Operating System Interview Questions. |
| ☺ | Disk Operating System (DOS) Interview Questions. |
| ☺ | Shell Scripting Interview Questions. |
