Do you know how can a D.P. transmitter be calibrated?
Submitted by: MuhammadD.P. transmitter can be calibrated using following steps:
1. Adjust zero of Xmtrs.
2. Perform static pressure test: Give equal pressure on both sides of transmitter. Zero should not shift either side. If the zero shifts then carry out static alignment.
3. Perform vacuum test: Apply equal vacuum to both the sides. Zero should not shift.
4. Calibration procedure: Give 20 psi air supply to the transmitter and vent L.P. side to atmosphere. Connect output of the instrument to the standard test gauge. Adjust zero. Apply required pressure to the high pressure side and adjust the span. Adjust zero gain if necessary.
Submitted by: Muhammad
1. Adjust zero of Xmtrs.
2. Perform static pressure test: Give equal pressure on both sides of transmitter. Zero should not shift either side. If the zero shifts then carry out static alignment.
3. Perform vacuum test: Apply equal vacuum to both the sides. Zero should not shift.
4. Calibration procedure: Give 20 psi air supply to the transmitter and vent L.P. side to atmosphere. Connect output of the instrument to the standard test gauge. Adjust zero. Apply required pressure to the high pressure side and adjust the span. Adjust zero gain if necessary.
Submitted by: Muhammad
Read Online Instrumentation Specialist Job Interview Questions And Answers
Top Instrumentation Specialist Questions
☺ | Do you know types of instrument cables? |
☺ | Tell me how the sizes of proximity switches are selected? |
☺ | Explain what will happen if thermocouple wires get shorted? |
☺ | Tell me what happens if transmitter wires get shorted? |
☺ | Tell me when do we use SOV of rating 110vac and 110vdc? |
Top Technical Support Engineer Categories
☺ | Instrumentation Interview Questions. |
☺ | CCTV Operator Interview Questions. |
☺ | Solar Panel Technician Interview Questions. |
☺ | Data Entry Operator (DEO) Interview Questions. |
☺ | Instrumentation Specialist Interview Questions. |