For the purpose of inflating car tyres, spray painting, etc. i.e. say a small workshop, what size of a compressor (CFM) is recommended? It will be generally for a hobby use and not commercial use?
Submitted by: Administratorspray painting it is generally used for painting in a very
smaller areas of any part and where it is very hard to paint
in a brush .... And to improve faster rate of painting,,
spray painting r used........usually reciprocating
compressor r used but size depends upon requirement...........
Submitted by: Administrator
smaller areas of any part and where it is very hard to paint
in a brush .... And to improve faster rate of painting,,
spray painting r used........usually reciprocating
compressor r used but size depends upon requirement...........
Submitted by: Administrator
Read Online Automobile Engineering Job Interview Questions And Answers
Top Automobile Engineering Questions
☺ | What is the formula for calculating BHP IN SI UNITS? |
☺ | WHAT IS TRANSVERSE WEIGHT SHIFT DUE TO DRIVE TORQUE? |
☺ | WHY THE COLOR OF VEHICLE TYRES ARE ALWAYS BLACK IN COLOUR. |
☺ | Why tractor rear wheel is big then front wheel? |
☺ | Explain different between two stroke engine four stroke engine? |
Top Best Engineering Categories
☺ | Mechanical Engineering Interview Questions. |
☺ | Civil Engineering Interview Questions. |
☺ | Chemical Engineering Interview Questions. |
☺ | Electrical Engineering Interview Questions. |
☺ | Automobile Engineering Interview Questions. |