What are the automatic controller MODES?
Submitted by: AdministratorFollowing are the mode of control. Ratio Control, PID
Control, PI Control, ON/OFF Control, Cascade Control,
Override Control, Feedback Control, Feed Froward Control.
These control are can be set in to MAN and AUTO Mode, If
this in MANUAL the mode of control is disable, If this is in
AUTO the mode of control is enable.
Submitted by: Administrator
Control, PI Control, ON/OFF Control, Cascade Control,
Override Control, Feedback Control, Feed Froward Control.
These control are can be set in to MAN and AUTO Mode, If
this in MANUAL the mode of control is disable, If this is in
AUTO the mode of control is enable.
Submitted by: Administrator
P, I, D are the different control modes. The words like cascade control, Ratio control refer to type of control
Submitted by: Vrkavi
Submitted by: Vrkavi
Read Online Instrumentation Engineering Job Interview Questions And Answers
Top Instrumentation Engineering Questions
| ☺ | Difference between mmwc and mmwg? |
| ☺ | Square root calculation for dp flow transmitter? |
| ☺ | What happen if i install my pressure transmitter below the elevation of pipe in natural gas service? |
| ☺ | why use MMWC unit? |
| ☺ | What is the meaning of wet leg & where is it used? |
Top Best Engineering Categories
| ☺ | Mechanical Engineering Interview Questions. |
| ☺ | Civil Engineering Interview Questions. |
| ☺ | Chemical Engineering Interview Questions. |
| ☺ | Electrical Engineering Interview Questions. |
| ☺ | Automobile Engineering Interview Questions. |
