Why plc require in analog input 4-20amp & 0-10 volt?
Submitted by: VishnuprasadBecause these are the signals which can change with respect to signal.4-20 mA signal is use because if it can start from 0-20 then if there is an signal of instrument is not equal to or less then original signal and if there instrument is show 10% open valve at 4 mA then we can test it with giving it less then 4 mA.
Submitted by: Rahul Khatri
Submitted by: Rahul Khatri
Read Online Instrumentation Engineering Job Interview Questions And Answers
Top Instrumentation Engineering Questions
| ☺ | Difference between mmwc and mmwg? |
| ☺ | Square root calculation for dp flow transmitter? |
| ☺ | What happen if i install my pressure transmitter below the elevation of pipe in natural gas service? |
| ☺ | why use MMWC unit? |
| ☺ | What is the meaning of wet leg & where is it used? |
Top Best Engineering Categories
| ☺ | Mechanical Engineering Interview Questions. |
| ☺ | Civil Engineering Interview Questions. |
| ☺ | Chemical Engineering Interview Questions. |
| ☺ | Electrical Engineering Interview Questions. |
| ☺ | Automobile Engineering Interview Questions. |
